Motion CMD-02 Manual Del Usuario página 4

M O TI ON C M D - 02 TUB U L AR M O TO R
1 Activate the motor
Activate the motor by moving the switch to 1.
2
3
4
5
Click!
Click!
Click!
M O T I O N C MD -02 T U B U LA R MO TO R
6 Pair a remote
Shortly press the program button with a pin on the
6.1
motor. The blind will start stepping, indicating that
program mode has been activated.
(The blind keeps stepping until the program mode
is deactivated.)
Press the pair button on the back of the remote
6.2
control to pair the blind.
The blind will shortly stop stepping indicating that the
remote has been paired to the blind.
Repeat steps 6.1 - 6.2 to remove a blind from
a channel.
End limits must be programmed to use a blind properly and to prevent it from being damaged.Proceed
to step 12 if end limits are already set.
7
Check rotational direction
WARNING: risk of damage.
Stop the blind before reaching
the end positions.
Pair
button
Shortly press the down button to check if the
7.1
Up blind unrolls the right way. If the blind moves
up, the rotational direction must be changed.
Down
Simultaneously press the up and down button
7.2
to change the rotational direction.