Eaton xChargeIn Instrucciones De Manejo página 115

xChargeIn
5.2.1 Preparing the charging station
To teach in the RFID master card and to delete the taught-in RFID cards, the
charging station must be rebooted via the service button. To access the ser-
vice button, proceed as follows:
5.2.2 Teaching in the RFID master card
The RFID master card is the card that is taught in as the first card at the
charging station. It is required for teaching in additional RFID slave cards. In
addition, it can also be used to authorize a charging process.
No charging session may be active for the teaching in and no vehicle may
be connected to the charging station.
Operating instructions V1.04
© EATON
1) Unscrew the two screws on the bottom of the housing
cover 1.
2) Lift the housing cover at bottom max. 1 cm
push upwards 2.
3) Unscrew the four screws of the connection panel cover
and remove the connection panel cover upwards.
The service button 1 in the connection panel is now acces-
sible.
Authorization
1 and then
1
115