AquaPRO 35034-5 Manual Del Usuario página 4

INSTALLATION
1.
Close the inlet valve of the city water and open the tap to discharge water.
position.
2.
NOTE: Install the emergency sump pump when the primary
sump pump isn't needed. Read the instruction and prepare all
suppliers before starting.
1).Verify that the existing primary sump pump is in good
working order. If the primary pump is questionable, replace with
the same or a higher HP pump. The primary pump is better to
have a vertical float switch or electrical switch. Tethered float
switch takes more sump pit space and might interfere with the
emergency pump.
2).Manually operate your primary sump pump and pump out
the water in your sump pit. Do not let the pump run dry. This will
damage the pump.
3).Disconnect the primary sump pump power source before
attempting to install. Never handle a pump with wet hands or
when standing on wet or damp surface or in water. Fatal
electrical shock could occur.
4).Remove any silt or accumulated debris from the sump pit
and surrounding area.
Install a Y pipe in the primary sump pump discharge pipe.
If necessary adjust the PVC pipe length so that nothing interferes
with the primary pump and switches.
4
Cut the city water pipe at a proper