Laser Overview; Keypad Overview; Turning On The Laser; Alert - Agatec LT 200 El Manual Del Propietario

1.3 Laser overview

See inside front cover for photos of the laser and keypad corre-
sponding to these callouts.
1. Rotating laser beam (head enclosed in glass lighthouse)
2. Charger jack
3. On / Off
4. Laser keypad

1.4 Keypad overview

5. Match slope / Beam up in calibration mode
6. Match slope / Beam down in calibration mode
7. Auto/Man key
8. H.I Alert
9. Rotation speed adjustment
10. LED for H.I. Alert / Y axis calibration
11. LED for manual mode / X axis calibration
2. How to use the LT200
2.1 Setup
• Horizontal
The laser can be used on a 5/8-11 tripod, on a wall mount, or
directly on a solid, stable surface.
The LT200 has a wide self-leveling range; however, if the laser
is set up out of the leveling range, laser beam will continue to
blink and rotation will not start.

2.2 Turning On the laser

Turn on the laser with the On/Off key (3). It does a self-test and
the beam blinks while the laser is self-leveling. After it's leveled,
the head rotates.
4
2.3 H.I. Alert
H.I. (height of instrument) Alert stops the laser automatically if
the laser is disturbed or moved, preventing inaccurate readings.
It will function only when selected. To activate this safeguard
feature, press the H.I. Alert key (8). The LED indicator (10) will
blink rapidly while the laser is self-leveling.
About 30 seconds after the head starts to rotate, the LED will
blink slowly, indicating the H.I. Alert is activated.
If the laser is disturbed while in H.I. Alert mode, the head will
stop rotating, the beam will turn off, and the LED will stay on.
To start the laser rotating again, press On/Off twice.
Check to see if the beam elevation has changed from its
original benchmark position.
The laser is no longer in H.I. Alert mode. Press key (8) to return
to H.I. Alert.
It is important to check while you're using the laser
that it has not been moved and that your setting is
still accurate.
2.4 Rotation

• Rotation speed

The head rotates at 3 speeds: 0, 90 and 600 rpm. To switch
from 0 to 90 and 600 rpm, press the rotation key (9). The laser
beam is more visible at slower rotation speeds. The faster speed
(600 rpm) is required for many machine control receiver appli-
cations.

2.5 Match Slope

The laser can be used to match manual slope on both X and Y
axes. Two modes are available: complete manual mode and
semi-automatic mode.
• Semi-Automatic Mode
Set the laser over a start point. Turn the laser so that the side of
the laser with the handle, +X, faces the direction of the slope
(and -X faces away; see axis direction in Section 3). Use the
sighting groove on the top of the housing to roughly align the X
axis of the laser to the second point.
5