Mount To 5 In./6 In. Housing With Ears; Turning Off The Power; Connecting The Cables - Commercial Electric 53191101 Manual De Uso Y Cuidado

Mount to 5 in./6 in. Housing with ears

1

Turning off the power

□ Make sure the power is turned off at the source to the
recessed can housing where the fixture will be installed.
Remove the existing bulb and trim, revealing the socket.
nOTiCe: Stick the replacement label on
the inner wall of the recessed housing before
installation.
3
Connecting the socket adapter
□ Screw the medium base (E26) socket adapter (B) into the
socket in the recessed housing.
B
Ears
2
Adjusting the spring clips
□ The factory setting of the spring clips is for 6 in. recessed
can housings. To install in 5 in. recessed can housings,
loosen the two screws in the brackets holding the spring
clips on both sides of the LED light module using a Phillips
screwdriver (not included).
□ Slide the brackets holding the spring clips inward until the
screws are in the 5 in. position, then tighten the screws
using a Phillips screwdriver (not included).
Bracket
Screw
4

Connecting the cables

□ Plug the cable connector on the socket adapter (B) into the
connector on the LED light module (A).
B
5
Please contact 1-877-527-0313 for further assistance.
Bracket
Spring
Clip
A
HoMEDEPoT.CoM