Trimming The Device; Donning The Device - Blatchford SBWTTCP22 Guia Del Usuario

9 Trimming the Device

The device may be trimmed to suit as required but never below the socket trim line.
We recommend using a rotating disc cutter to achieve a bevelled edge.
Avoid trimming through the perforations.
Trim the proximal edge of the device to suit the shape of the user's socket.
If necessary, trim the proximal edge of the device in a wave pattern to reduce shear stress.
Where possible try to avoid abrupt changes of contour and sharp edges which could
cause tears in the silicone and fabric.

10 Donning the Device

Before you begin
Fit the valve to the locking liner. (See Fitting the
Valve section.)
Care must be taken during donning/doffing
not to damage the device with fingernails,
sharp jewelry or the locking pin.
Do NOT pull or stretch the device.
1. Invert the device so that its silicone side points externally.
2. Align the locking pin with the long axis of the residual
limb. (Locking liner only.)
3. Roll the device on the residual limb while releasing any
trapped air.
After donning the device, allow the user to wear it for 10 minutes. If the user feels numbness,
tingling or any unusual sensation within 10 minutes, do the following:
4. Doff the device, and wait until normal sensation returns.
5. Don the device again.
6. If the user feels numbness, tingling or any unusual sensation again, stop using the device.
9
938461PK1/1-0121