Functional Description - Makita DMR300 Manual De Instrucciones

INTRODUCTION
Parts description
Body
► Fig.1: a) Left side b) Front c) Right side d) Back (battery cover closed) e) Back (battery cover opened) f) Top
1 Handle
5 Volume/Tuning control/
Select knob
9 Hook for AC adaptor
13 Slot for CXT battery
cartridge
17 Battery compartment
locker
Buttons and LCD display
► Fig.2
1 Power/Sleep timer
button
5 "TIMER TO ALARM"
icon
9 Icon for sleep timer
13 Error icon for charging
failure
17 Information area
NOTE: DAB is only receivable with DMR301.
Installing back up batteries
NOTE: Keeping back up batteries inside the compart-
ment prevent stored data in preset memories from
being lost.
1.
Pull up the battery compartment to unlock it and
then open the battery cover.
► Fig.3: 1. Battery compartment locker 2. Battery
cover
2. Remove back up battery compartment cover and
install 2 fresh UM-3 (AA sizes) batteries. Make sure the
batteries are with correct polarity as shown inside the
compartment.
► Fig.4: 1. Back up battery compartment cover
3. Close the back up battery compartment cover.
2 Soft bended rod antenna
6 Auxiliary input socket
(AUX IN 1)
10 Bottle cap opener
14 Auxiliary input socket
(AUX IN 2)
18 Power cord
2 Source button
6 "TIMER TO SPEAKER"
icon
10 PM indicator for clock
14 Indicator for battery
status/capacity
18 Preset stations/Preset
®
1 button as Bluetooth
pair button
3 Speaker
7 USB power supply port
11 Battery cover
15 USB power supply port
19 AC power adaptor
3 Radio alarm button
7 Icon for delay charge
11 Stereo symbol
15 Indicator for AC power
supply
- -
FUNCTIONAL
DESCRIPTION
Installing or removing battery
cartridge
CAUTION:
Hold the tool and the battery car-
tridge firmly when installing or removing battery
cartridge. Failure to hold the radio and the battery
cartridge firmly may cause them to slip off your hands
and result in damage to the radio and battery car-
tridge and a personal injury.
Pull up the battery compartment to unlock it and then
open the battery cover.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator on the
upper side of the button, it is not locked completely.
► Fig.5: 1. LXT battery cartridge 2. CXT battery car-
tridge 3. Red indicator 4. Button
To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge.
After installing/removing the battery cartridge, be sure
to close the battery cover.
10 ENGLISH
4 Menu/Info button
8 DC IN socket
12 Slot for LXT battery
cartridge
16 Battery compartment
(covering back up
batteries)
- -
4 Buzzer alarm button
8 Band
12 No power indicator
16 Clock
- -