Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Maintenance
CAUTION: In a double‐insulated product, two systems of insulation are provided instead of grounding. No grounding means is
provided on a double‐insulated product, nor should a means for grounding be added to the product. Servicing of a double‐
insulated product requires extreme care and knowledge of the system, and should be done only by qualified service personnel.
Replacement parts for a double‐insulated product must be identical to those parts in the product. A double‐insulated product is
marked with the words "DOUBLE INSULATION" or "DOUBLE INSULATED". The symbol
REPLACING THE FUSE
This unit is equipped with fuse protection. If at some point the inflator fails to operate when using the 12 Volt DC power
method, follow the procedure below to check the fuse in the end of the 12 Volt plug.
□
Unscrew the 12 Volt power plug tip.
Remove and inspect the existing fuse.
□
If a new fuse is needed, install a new fuse of the same type into the 12 Volt power plug.
□
Reassemble the power plug.
□
Care And Cleaning
Set the power selector switch to the off or "O" position, and unplug the cord.
□
□
Wipe plastic parts clean using mild soap and warm water. Do not get moisture or water into any interior moving parts.
Troubleshooting
Problem
The inflator does not start.
Possible Cause
The preset pressure setting may be below
the actual pressure of the item you are
inflating.
The power cord is not plugged in.
The circuit breaker is tripped.
The fuse in the 12 Volt vehicle cord is
blown.
Solution
Adjust the preset pressure setting to a higher
pressure.
Plug the power cord into a working power
outlet.
Reset the circuit breaker.
Replace the fuse.
5
Please contact 1‐888‐43‐HUSKY for further assistance.
may also be marked on the product.
HUSKYTOOLS.COM
Capítulos
Tabla de contenido
