Tabla de contenido
Idiomas disponibles
Idiomas disponibles
FEATURES OF YOUR NEW DISHWASHER
How your dishwasher cleans
Your dishwasher cleans by spraying
a mixture of hot water and detergent
through the spray arms
against
soiled surfaces.
The dishwasher fills with water,
covering the filter area. Water is then
pumped through the multiple filters
and spray arms. Separated soil
particles go down the drain as the
water is pumped out and replaced
with clean water.
The number of water fills will vary
with the cycle being used.
Getting Started
1.
Load the dishwasher (See Dish Preparation and
Loading sections).
2.
Add detergent (See Filling the detergent dispenser).
3.
Add rinse aid (See Filling the rinse aid dispenser).
4.
Select desired CYCLE (See Cycle Chart).
5.
Select desired OPTIONS (See Control Panel).
The indicator light above the pad will glow when
selected.
6.
Run the hot water faucet closest to the dishwasher
until the water is hot, then turn it off.
7.
To start, press Start/Cancel (See Control Panel),
then close the door.
Note:
Your dishwasher has the controls mounted
in the front of the door. The door should be
closed before operating the machine.
Wash Cycle Selections
Cycle times are approximate and will vary with the
options selected. Hot water is necessary to activate
the detergent and melt fatty food residues. An automatic
sensor will check the incoming water temperature. If
it is not at the appropriate temperature the timer will
delay the cycle to allow automatic water heating during
the main wash. When the HI-TEMP wash is selected
an even higher temperature will be set to handle
heavier soil loads.
5
Capítulos
Tabla de contenido
Solución de problemas
