Error Codes - Forno FDWBI8004-24S Manual De Instrucciones

Error Codes

When malfunctions occur, the appliance will display error codes to warn you:
during the water inlet step, if the flow meter
E1
can't detect the water after 4
minutes, the dishwasher will post an E1 error message.
(only appears in factory mode)
E3
when the temperature cant reached the defined value
after 90 minutes, the dishwasher will post an E3 error message.
If water floods into the bottom and triggers the detector switch, will
E4
post an E1 error message
the dishwasher will post an E4 error message
E6
(only appears in factory mode)
E6 - thermal sensor cut.
E7
E7 - thermal sensor short.
If pushing one button for more than 30s, the
E9
dishwasher will post an E9 error message.
If the Dashboard detects that the communication data is
Ed
abnormal for more than 30s, the dishwasher
will post an Ed error message.
WARNING
If overflow occurs, turn off the main water supply before calling a service provider.
If there is water in the bottom pan due to overfilling or a small leak, the water
should be removed before restarting the dishwasher.
1. check the water supply
2. check the inlet valve
3. check the inlet
4. check the flowmeter
5. check the pressure switch
6. check the drain
7. check the PCB
1. check the heater
2. check the thermistor
3. check the PCB
1. check the use of detergent
2. check whether the appliance is level
3. check the micro-switch
4. check the drain pump
5. check the water fill level
6. Locate the leak
1. check the inlet water temperature
2. check the thermistor
3. check the PCB
Button sticks,warning resolved when
releasing the buttom
communication data abnormal, warning
resolved when communication data returns
to normal.
1 7