Protection; Waste Disposal - Ugin ARTIS NEO Modo De Empleo

Instructions for use (rev 290319) ARTIS NEO

11. PROTECTION

 PROGRAMS
Your programs are protected by an EEPROM memory, which operates without batteries.
 OVERVOLTAGE
The power supply to furnaces with micro-processing units requires perfect filtering. The ARTIS
NEO furnace is protected against over-voltage by a system of active and passive filters. However,
very high over-voltages may interfere with your programs.
As a precautionary measure, we recommend that you keep a record of your programs in the
notebook provided for that purpose.
 "WATCHDOG"
A separate circuit continually monitors microprocessor operation. In the event of a malfunction, it
switches the unit to safeguard status.
 OUTLET VOLTAGE VARIATION
Within a limit of ±20 volts, the furnace self-corrects the variation and maintains the same
accuracy.
 INTERRUPTION OF POWER SUPPLY
If the power supply is cut off, the cycle stops but will begin again at the same point once the
mains voltage is re-established.
Depending on the length of the interruption, the operator will decide whether to continue or
cancel the cycle.

12. WASTE DISPOSAL

Observe the waste disposal regulations for electrical and electronic equipment: do not dispose
of with household waste.
The unit is subject to Directive 2012/19/EU on waste electrical and electronic equipment and to
the laws of the country in which it is being used, and must be disposed of in accordance with
applicable regulations.
UGIN DENTAIRE 35