Warn PN 64500 Manual Del Usuario página 4

Step Four: Remote Socket
Installation
TO PREVENT SERIOUS INJURY OR DEATH FROM
•
•
10-24 hex nut &
lockwasher
Keyway must
point down
10-24 hex nut &
hex head capscrew
Figure 6. Remote socket installation.
• After determining the mounting location for the
• Once the remote socket is mounted, route the two
Figure 7: Use a test light to locate a
suitable wire.
| Warn Industries, Inc.
5
WARNING!
EXPLOSION:
Do not drill into gas tank.
Verify the area is clear behind the mounting
location before drilling.
1/4in. (6.4 mm) diameter, 2 places
7/8in. (44.5mm)
7/8in. (22.2mm) diameter
1-3/4in. (44.5mm)
Not to scale. Do not use as a template!
remote socket, drill three holes and install. (see
figure 6)
bullet terminal wires back to where the contactor
will be mounted. Splice the end of the red 20ga wire
to a key controlled electrical wire of the ATV (use
the provided wire splice). Using a test light, locate a
suitable wire from the ATV key switch. The wire
should only have power when the key is in the "ON"
position.
Blue
(6 ga.)
Yellow
(6 ga.)
Black
(6 ga.)
Blue
(6 ga.)
Yellow
Red
(6 ga.)
(6 ga.)
Figure 8. Wiring Installation diagram
Step Five: Wiring Installation
Place the supplied terminal boots on wires before
securing to the contactor. All wires must be
attached to the contactor before mounting the
contactor to the ATV.
• Attach the yellow and blue labeled 21 in (0.5m) 6ga
wires to the yellow and blue motor terminals on the
winch. Yellow is marked #1 and blue is marked #2
on the end of the motor cap.
• Attach the yellow and blue 48 in (1.2m) and 96 in
(2.4m) 6ga wires to the contactor and connect to
the yellow and blue contactor posts. Reference the
lower right-hand corner of figure 8 to see how to fit
two wire terminals onto the contactor posts.
• Attach the terminals on the green and black remote
socket wires into the contactor (green to green, black
to black).
WARN 2.5ci Winch Multi-Mount Installation and Specification Guide |
Red
(20 ga.)
Green
Black
CAUTION!
6