Inficon WEY-TEK Manual Del Usuario página 3

A Communication Cable: The communication cable connects the Weigh
Platform and the Control Hand Piece. Insert an end of the cable into each
component. Ensure the cable is secure by listening for a "click" when attaching the
cable.
B Battery Compartment: The Wey-TEK operates on a 9 volt alkaline battery.
Install the battery by sliding open the access door in the back of the control hand
piece and snapping it onto the connector.
C ON/OFF Switch: Press the button once to either turn the Wey-TEK on. Depress
the button for one second to turn the WEY-TEK off. When turned on, the Wey-TEK
will perform an initialization test.
D Unit Selection: The Wey-TEK will display weight measurements in decimal
pounds (XXX.XX lbs), pounds and ounces (XXX lbs XX.XX oz) or kilograms
(XXX.XX kg). Push this button to toggle between units.
E Tare (Zero): This button allows you to manually zero the Wey-TEK at any time
during operation. NOTE: When first turned on, the Wey-TEK will automatically
zero.
F Display: Indicates how much weight has been placed on or taken off the Weigh
Platform. The display will show positive and negative values. If the scale goes
over its weight limit, the display will say "Over Range". When the battery becomes
low the display will say "Low Battery" (steady at first but flashing when the scale is
about to shut off). When the battery power is too low to provide an accurate
reading, only "Change Battery" will show on the display. If the scale cannot auto
zero because maximum weight is exceeded during initialization, the message
"Over Range - Remove Weight" will be displayed.
Auto Shut Off: To extend battery life, the Wey-TEK Scale will shut off in 30
minutes. When restarted after an auto shut off, the Wey-TEK will perform its
initialization test and automatically zero. There is a provision in the Wey-TEK
software to disable the auto shut off feature. Contact INFICON for instructions
A
B
E
F
C
D
3