Maintenance
MUD BUGGY
44
ENGINE
Refer to engine manual for specific engine information.
Engine Oil
Engine Oil
Engine Oil
Engine Oil
Engine Oil
1. Change oil after the first 50 hours, then change oil every 100 hours under normal
use. For severe service, change engine oil every 50 hours.
2. Remove the oil filler cap and drain bolt. Drain oil into a suitable container
3. Clean and install the drain bolt, tighten securely.
4. Fill with recommended oil to the upper limit mark on the dipstick. Install and
tighten the oil filler cap securely.
5. Run engine for 2 – 3 minutes, stop engine and check oil level.
N N N N N o o o o o te:
te:
te:
te:
te: Please dispose of used motor oil in a manner that doesn't harm the environment.
Oil Gr
Oil Gr
ade and Capacity
ade and Capacity
Oil Gr
Oil Gr
Oil Grade and Capacity
ade and Capacity
ade and Capacity
Engine requires 1.16 quarts/1.1 liter.
•
Over 40 Degrees Fahrenheit/13 Degrees Celsius
•
Below 40 Degrees Fahrenheit/13 Degrees Celsius
E NGINE IS EQUIPPED WITH L
E N
E N
GINE IS EQUIPPED WITH LOW OIL SHUT DOWN
GINE IS EQUIPPED WITH L
GINE IS EQUIPPED WITH L
E N
E N
GINE IS EQUIPPED WITH L
Air F
Air F
ilter
ilter
Air F
Air F
Air Filter
ilter
ilter
Check air filter before each use and clean after every 50 hours of service.
Clean primary (outer) element at 50 hours (after break-in period) then every 50 hours or 12
months.
Service air cleaner more frequently in dusty conditions.
IMPOR
IMPOR
IMPORT T T T T ANT
IMPOR
IMPOR
ANT
ANT: : : : : DO NOT operate engine without the filter cover.
ANT
ANT
1. Remove air cleaner cover.
2. Remove primary (outer) element only.
3. Thoroughly clean all dirt from inside filter housing. Insert the air nozzle into
element, hold air nozzle about 1" (25.4 mm) from perforated metal retainer. Force
air (30 psi max) through filter from inside to outside and move air gun up and down
pleats to remove as much dirt as possible.
IMPOR
IMPORT T T T T ANT
IMPOR
ANT: : : : : Only a special air cleaning gun should be used. Concentrated air pressure from
ANT
ANT
IMPOR
IMPOR
ANT
an ordinary nozzle may severely damage filter element. DO NOT exceed 30 PSI (2.1 bar) when
cleaning filter element.
4. Inspect filter to determine if it is practical to clean or for damage after cleaning
filter. If necessary, repeat step three to remove additional dirt.
a. Hold a bright light inside element--check carefully for holes. Discard any
element that shows the smallest hole or rupture.
b. Be sure outer screen is not dented. Vibration would quickly wear a hole in
filter.
c. Be sure filter gasket is in good condition. If gasket is damaged or missing,
replace element.
WARNING
OW OIL SHUT DOWN. UNIT WILL SHUT DOWN IF
OW OIL SHUT DOWN
OW OIL SHUT DOWN
. UNIT WILL SHUT DOWN IF
. UNIT WILL SHUT DOWN IF
. UNIT WILL SHUT DOWN IF
OW OIL SHUT DOWN
. UNIT WILL SHUT DOWN IF
E N
E N
GINE OIL IS L
GINE OIL IS L
O W
O W. . . . .
O W
E N
E N
E NGINE OIL IS L
GINE OIL IS L
GINE OIL IS LO W
O W
SAE 30
SAE 20