Pre-Maintenance Procedures; Preparing For Maintenance; Engine Maintenance; Servicing The Air Filter - Toro 58620 Manual Del Operador

Pre-Maintenance
Procedures

Preparing for Maintenance

1. Move the machine to a level surface, shut off the
engine, and wait for all moving parts to stop.
2. Disconnect the spark-plug wire from the spark
plug.
1. Spark-plug wire
3. After performing the maintenance procedure(s),
connect the spark-plug wire to the spark plug.
Important:
Before tipping the machine to
change the oil or replace the blade, allow the
fuel tank to run dry through normal usage. If
you must tip the machine prior to running
out of fuel, use a hand fuel pump to remove
the fuel. Always tip the machine onto its
side, with the dipstick down.
Figure 11

Engine Maintenance

Servicing the Air Filter

Service Interval: Every 25 hours
Yearly
1. Unclip the top of the air-filter cover.
g339525
1. Clip
2. Air-filter cover
2. Remove the air filter.
3. Inspect the air filter.
Note:
If the air filter is excessively dirty, replace
it with a new filter. Otherwise, gently tap the air
filter on a hard surface to loosen debris.
4. Install the air filter.
5. Use the clip to install the air-filter cover.

Changing the Engine Oil

Service Interval: Yearly
Changing the engine oil is not required, but if
you want to change the oil, use the following
procedure.
Note:
Run the engine a few minutes before changing
the oil to warm it. Warm oil flows better and carries
more contaminants.
Engine Oil Specifications
Engine oil capacity
Oil viscosity
API service classification
13
Figure 12
3. Air filter
0.44 L (15 fl oz)*
SAE 30 or SAE 10W-30
detergent oil
SJ or higher
g334791