Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
6 19 TRANSMISSION ENGAGE/DISENGAGE
LEVER (19)
A lever for disengaging the variable transmission.
The engage / disengagelever must
never be between the outer and inner
positions This overheats and damages
the transmission
The levers allow the user to move the machine
manually (pushing or pulling), without the engine
running. The two positions are:
1 Transmission disengaged =
lever out For normal use, locking
of the lever in this position is
confirmed by a click.
2 Transmission disengaged = transmission
disengaged. The machine can be moved by hand.
The machine must not be towed over long distan-
ces or at high speeds. The transmission could be
damaged.
Never activate the machine with the
transmission disengaged (lever in)
Risk of damage and oil leakage in the
front axle
6 20 SEAT ADJUSTMENT (20)
The seat can be moved backwards and forwards
to suit the driver as indicated below:
1. Move the control lever (20:A) upwards.
2. Set the seat to the desired position.
3. Release the control lever (20:A) to lock the seat.
Using the relative knob (20:B) [740 IOX / 540 IX] it
is also possible to adjust suspension rigidity.
• Turn the knob clockwise for tighter suspension.
• Turn the knob anticlockwise for slacker su-
spension.
Act on the knob until you reach the re-
quired level of comfort
The seat is equipped with a safety switch that is
connected to the machine's safet y system. This
means that when no-one is sitting in the seat the
machine cannot be started (see 7.8.2).
6 21 QUICK-RELEASE SUPPORTS (21; 22; 23)
These support allows the user to swap from
one attachment to another quickly and easily.
The quick-release supports allow the user to move
the cutting mean assembly quickly and easily
between two positions, i.e.:
• Normal position with the belt fully tensioned.
• Positioned 4 cm behind the normal position,
16
ENGLISH
with the belt slackened, so that the cutting
mean assembly moves closer to the base of
the machine.
Being as the belt tensioner is released from the
belt, the quick-release supports simplify belt and
cutting mean assembly replacement, and also
make shifting to the washing position and service
positions easier.
Belt tension releasing (21)
See also the instructions provided with
the accessory and with the quick-relea-
se support
1. Remove the cotter pins or lock pins (21:C)
from both sides.
2. Open the quick-release supports by pressing
on their rear sections with your heel (21:A).
Once the quick-release supports have
been opened, the arms of the accesso-
ry are free and no longer secured to the
hook-up device
For any adjustment or maintenance
operation, replace the arms on the sup-
port and reclose
3. Carry out the necessary corrective action, e.g.:
•
Release the belt.
•
Replace the accessory by unhooking the
arms (22).
Tensioning the belt (21, 22)
First tension one side and then the other accor-
ding to the instructions provided below.
Do not turn the lever using your hands
Risk of crushing injuries
1. Place your foot on the lever (22:A) and care-
fully turn it 180° forwards.
2. Install the cotter pin or lock pin (21:C).
3. Repeat the operation on the other side.
7 START-UP AND OPERATION
7 1
PRECAUTIONS FOR USE
Always make sure the engine oil level
is correct This is particularly important
when operating on slopes (see 7 66)
Apply the parking brake when you park the
machine.
Do not turn the steering wheel to full
lock when driving at full speed The ma-
chine may overturn
(Translation of the Original Instructions)
Tabla de contenido
