PocketWizard PLUS III Guia De Inicio Rapido página 5

NOTE: This Plus III can work with any PocketWizard
Standard Channels. Visit wiki.PocketWizard.com for more information.
Connect transmitting Plus III to camera hot
shoe. Tighten locking ring.
Plus III Transceiver Basics
Connecting:
Connect a Plus III to your camera via the hot shoe. This will be your transmitting
radio. Connect a Plus III to each of your remote flashes using the appropriate
sync cable. These will be your receiving radios.
NOTE: If you are using a camera with no hot shoe, or the hot shoe cannot be used,
connect the transmitting Plus III's Flash/Camera Port to the camera's sync terminal.
Visit PocketWizard.com/support/cable_finder for correct camera cable.
Powering On/Off:
Make sure batteries are properly installed (PG. 4). To turn on your Plus III, hold
down the Power/MODE Button
green every few seconds to indicate normal operation. It will blink red when a
trigger is transmitted or received. Hold down the Power/MODE Button for about
two seconds to turn off your Plus III.
Channels & Zones:
Your Plus III needs to be on the same channel as other PocketWizard radios to
work together. Channels can be set via the Plus III's Channel Up/Down Buttons
. When using Channels 17-32, you can specify Zones A, B, C, and D. You
may have as many remote Plus III Transceivers on the same channel as you
would like. See "Channels and Zones" section (PG. 11) for more info.
Transceiver
radio transmitting or receiving on
®
Connect receiving Plus III to remote flash
with appropriate sync cable. A PocketWizard
transceiver/receiver is required for each
remote flash.
for about two seconds. The Status LED blinks
5