Other Functions; Status Led - PocketWizard PLUS III Guia De Inicio Rapido

Other Functions

TEST Button (Two Stage Trigger)
Half-pressing
a remote camera connected to a receiving PocketWizard
remote -ACC camera cable (available separately). This wakes up the cam-
era and makes it respond more quickly and consistently, but also reduces
battery life. Half-pressing the TEST button will not affect remote flashes.
wiki.PocketWizard.com
See
Fully pressing
nected to receiving PocketWizard radios set to the same channel and zones.

Status LED

The Plus III's status LED will blink in three different colors: Green, Red and Amber.
Green Blinking indicates good battery life.
Amber Blinking indicates the batteries are getting low or when TEST
button is half-pressed.
Red
Blinking indicates batteries are critically low and should be changed
immediately. The status LED turns solid red when Plus III is
transmitting or receiving a trigger.
Reset
To reset your Plus III Transceiver to the default setting, hold the TEST button
as you power the radio on. The default mode after a reset is TxRx on
Channel 17 with all Zones enabled.
USB
The Plus III can be powered via USB with a compatible AC adapter or from most
computers. Future firmware updates can be installed via the PocketWizard Utility.
the TEST button on a transmitting Plus
for more information.
the TEST button fires any remote cameras or flashes con-
III pre-releases
®
radio with a
®