Adjus Ng The Burrs - Mahlkonig E80 SUPREME Instrucciones De Uso

ESPRESSO GRINDER
recess in the removal tool slightly off -centred beneath the burr. Guide
the removal tool into the centre of the burr and remove the burr by
li ing it upwards.
5. Remove the residual coff ee grounds from the grinding chamber using a
handheld vacuum cleaner.
Make sure that the burr carrier is completely clean.
6. Place the new rotary burr on the burr carrier and ghten the two screws
using a fl at-head screwdriver.
7. Remove the removal tool. Replace the fl apper into the recess in the
grinder.
8. Clean the fi x burr fl ange and screw holes using a wire brush.
Make sure that the fi x burr fl ange is completely clean.
9. Place the new fi xed burr onto the fi x burr fl ange and ghten the two
screws using a fl at-head screwdriver.
10. Place the fi x burr fl ange onto the grinding chamber; proceed as de-
scribed in chapter "Cleaning the grinding mechanism manually" steps
9–12.

Adjus ng the burrs

1. Remove the grinder lid (25), proceed as described in chapter "Cleaning
the grinding mechanism manually" steps 1–4.
2. Remove any excess beans from the grinding chamber.
3. Set the grinding degree slider (15) to "0" on the grinding degree scale
(16).
4. Push the lock on the adjustment ring (36) backwards and remove the
adjustment ring (37) from the grinder by li ing it up and out (see Fig. M).
5. Rotate the burrs by turning the screw of the burr carrier (30) using a fl at-
head screwdriver in a clockwise direc on.
Repeat this process several mes during the adjustment.
6. Turn the dial zero adjustment (40) towards the lowest point on the Verni-
er scale (39).
If you can hear a grinding noise, the distance between the burrs is at its
smallest.
7. Slowly turn the dial zero adjustment towards the highest point on the
Vernier scale un l you can no longer hear a grinding noise.
The burrs are zeroed in.
8. Place the adjustment ring onto the grinder.
66