Installation Instructions - Utilitech Pro MXL-301 Manual De Instrucciones

INSTALLATION INSTRUCTIONS

With power disconnected to your electrical box, remove the old fixture. If the old fixture is
attached to an electrical box that has more than two (2) wire leads, use tape and
markings to keep track of which wires were attached to each other.
1. Two people are required for this step. Pull open the two
end caps (B) on the side of the fixture. Align the fixture
with the junction box so that the junction box is covered.
One person should hold the fixture in this position and
the second person should mark the four locations of the
mounting holes at both ends of the fixture. Set the
fixture (A) aside.
2. DRYWALL MOUNTING: If the mounting holes go
through drywall without a stud, drill four small pilot
holes using a 1/8-in. drill bit (not included), and install
drywall anchors (BB) into the holes with a hammer
(not included).
CEILING STUD MOUNTING: If the mounting holes
go through ceiling studs, drill four small pilot holes
using a 5/32-in. drill bit (not included) for the wood
screws (CC). NOTE: Do not install wood screws
(CC) yet.
Hardware Used
Drywall Anchor
BB
1
A
B
2
BB
Drywall
Pilot hole
Ceiling
Drywall Mounting
Stud Mounting
x 4
Lowes.com
4
INSTALLATION INSTRUCTIONS
3. Two people are required for this step. Check that
black, white and green wires are extending from the
back of the fixture (A). Ensure that power is shut off.
One person should hold the fixture (A) up to the
junction box and the second person should connect
the supply wires to the fixture wires -- black to black,
white to white, and green to copper/bare.
WARNING: If there is no ground supply wire, stop
installation and consult a qualified electrician.
Once wire connections are made, secure each with a
B
wire nut (AA) and tuck all wiring into the junction box.
Hardware Used
Wire nut
AA
4. Align the fixture (A) so that the mounting holes match
Ceiling Stud
up to the pilot holes or drywall anchors (BB). Ensure
that the wiring is tucked into the junction box behind the
fixture (A). Secure the fixture (A) to the mounting
surface using all four wood screws (CC).
Hardware Used
Wood Screw
CC
3
AA
A
AA
A
x 3
4
x 4
CC
Lowes.com
5
A