Installation Instructions - Utilitech Pro MXL2005-LED1X10K840 Información De Seguridad

INSTALLATION INSTRUCTIONS

2.Lift the fixture lens cover (B) off the fixture plate (A)
and unplug the connectors to release the fixture lens
cover (B). Set the fixture lens cover (B) aside.
3.Place the fixture plate (A) on a sturdy surface with the
back side facing up and use a screwdriver to punch
out one of the knockout holes.
4. Align knockout hole with the supply wire location on
the mounting surface and hold the fixture up in its
intended location with one hand while marking the
location of the two keyhole slots at each end of the
fixture plate.
2
B
A
Disconnect connectors
3
Punch through
knockout
A
Mark these
4
locations
A
Lowes.com
4
INSTALLATION INSTRUCTIONS
5. DRYWALL MOUNTING: If the mounting holes go
through drywall without a stud, drill two small pilot
holes using a 1/8-in. drill bit (not included), and install
drywall anchors (BB) into the holes with a hammer
(not included). Install the two wood screws (AA) into
the mounting surface but leave about a 3/8-in. gap
between the screw head and mounting surface.
WALL STUD MOUNTING: If the mounting holes go
through wall studs, drill two small pilot holes using a
5/32-in. drill bit (not included) for the wood screws
(AA). Install the two wood screws (AA) into the
mounting surface but leave about a 3/8-in. gap
between the screw head and mounting surface.
Hardware Used
Drywall Anchor
BB
Wood Screw
AA
6. Feed the supply wires from the mounting surface
through the knockout hole on the fixture plate. Guide
the heads of the two wood screws into the keyhole
slots and slide the fixture plate (A) in the direction such
that the wood screw heads rest over the narrow part of
the keyhole slot. Ensure that the fixture is supported
and tighten the two wood screws until the fixture is
secured to the mounting surface.
5
Drywall BB
Pilot hole
Drywall Mounting Wall Stud Mounting
x 2
x 2
6
A
AA
Lowes.com
5
Wall Stud
A
AA