Maintenance - Skymsen CR-4L Manual De Instrucciones

6. Maintenance

Maintenance must be considered a set of procedures with the purpose to keep the
equipment best operating conditions, therefore increasing the equipment life and safety.
*Cleaning – check item 3.4 Cleaning
*Wiring - Check all wires regarding deteriorate conditions as well as all electric contacts
(terminals) regarding tightening and corrosion.
*Contacts – ON/OFF switch, emergency button, reset button, electronic circuits etc, check
the equipment in order to assure that all components are correctly working and the
equipment operation is normal.
*Installation – make sure the installation followed item 2.1 instructions
*1 – Each month check :
-Check the electrical installation
-Measure the voltage at the socket
-Measure the working current and match it with the nominal current
-Check the tightening of all electric terminals to avoid bad contacts
-Check electric motor shaft clearance
-Check the wiring for overeating, insulation failures and mechanical damages.
*2 Each three month checks
-Check electrical components such as ON/OFF switch, emergency button, reset button,
electronic electric circuits, overeating, insulation failings, or mechanical damages
-Check bearings clearances
-Check retainers, O'rings, V'rings and other seals
18