Baby Jogger City Go Manual Del Usuario página 20

BASE INSTALLATION - LATCH
1
2
3
4
CLICK
Before installing base, make sure vehicle is on
level ground. Place base on an approved LATCH
vehicle seating location.
1 Remove LATCH strap from LATCH storage
compartment and extend the strap to the
longest length. Lay the anchor strap between
the 2 guide lines on the base. Route the
LATCH belt through the belt path openings on
both sides of base and under the belt lock-off.
Make sure not to twist the belt and make sure
it lies flat.
2 Press the LATCH connectors onto the adjacent
vehicle anchors until a click is heard. Pull the
LATCH connector to verify a secure lock.
3 While pressing the base down into the seat, pull
up on the LATCH adjuster strap to tighten. To
loosen the LATCH adjuster strap, press button
on latch buckle and pull.
4 Close the lock-off over the LATCH belt until it clicks
into place. Always store the excess webbing to
ensure a secure car seat fit.
No te: Check to make sure base is secure by holding
both sides of the base near the LATCH strap and
moving it from side- to-side and front-to-back. The
LATCH belt should not loosen and the base should
not move easily. The base should not move more
than 1 inch from side to side or front to back.
20