Lap Belt Only - Baby Jogger City Go Manual Del Usuario

SEAT INSTALLATION - LAP BELT ONLY
1
2
3
4
line MUST be level
RED
with the ground when
installed in vehicle
WITHOUT the base.
Before installing carrier, make sure vehicle
is on level ground. Place carrier on an
approved vehicle seat location.
1 Place the car seat rear-facing on the
vehicle seat. Route the vehicle belt
through the belt guides on both sides of
carrier. Make sure the belt lies flat and is
not twisted.
2 Fasten the buckle until it clicks into place.
3 Push down in center of carrier and pull the
free end of the lap belt to tighten carrier
against the vehicle.
No te: Check to make sure carrier is secure
by holding both sides near the lap belt
guides and moving it from side to side
and front and back. The lap belt should
not loosen and the carrier should not
move easily. The carrier should not move
more than 1 inch from side to side or
front to back.
4 After installing carrier without base, check
the red level line on the label beneath the
handle to make sure that it is level with
the ground.
17