Lap/Shoulder Belt Only; Lap/Shoulder Belt - Baby Jogger City Go Manual Del Usuario

SEAT INSTALLATION - LAP/SHOULDER BELT ONLY
1
2
3
4
5
line MUST be level
RED
with the ground when
installed in vehicle
WITHOUT the base.
Before installing carrier, make sure vehicle is
on level ground. Place carrier on an approved
vehicle seat location.
1 Place the car seat rear-facing on the
vehicle seat. Route the lap portion of the
lap/shoulder belt through the lap belt
guides on both sides of carrier. Make sure
the belt lies flat and is not twisted.
2 Fasten the buckle until it clicks into place.
3 Route the shoulder portion of the belt around
the rear of the seat and under the shoulder
belt guide. If vehicle belt latch plate does not
lock, then retractor must be switched.
4 Pull on shoulder portion toward the
retractor while pressing down on the
center of the carrier to tighten carrier to
vehicle seat.
No te: Check to make sure carrier is secure by
holding both sides near the lap belt guides and
moving it. The lap belt should not loosen and
the carrier should not move more than 1 inch
from side to side or front to back.
5 After installing the carrier without base, check
the red level line on the label beneath the
handle to make sure that it is level with the
ground.
18