Operation - Husqvarna HA110 Manual Del Usuario

To install the suspension ring if
applicable
1. Install the suspension ring between the arrows on
the rear handle and the loop handle.
Note: Do not put the loop handle on the decal.
2. Adjust the ring to make the product balanced, and
easy to use.
To assemble the cutting head
It is important that the hedge trimmer is laid on a flat
surface when you fit the cutting head. Otherwise the
cutting head may not be fitted straight.
1. Fit the cutting head to the shaft.
To do a check before start
1. Examine the work area. Remove any objects that
could be thrown out.
2. Examine the cutting attachment. Do not use blades
that are damaged.
3. Examine that the product is in perfect work order.
Examine that all nuts and screws are tight.
4. Make sure the gear housing is lubricated correctly.
To lubricate the gear housing on page 11 for
See
instructions.
5. Examine that the cutting attachment stops when the
throttle/power trigger is released.
6. Only use the product for the purpose it was intended
for.
820 - 003 - 07.02.2020
2. Tighten the lower screw first, then the upper screw.
To assemble the handle (HA850)
1. Install the handle with the 2 screws.

Operation

7. Make sure that the handle and safety features are in
good working order. Never use a product that lacks a
part or has been modified outside its specifications.
To operate the product
1. Work with a swinging action from the bottom
upwards when trimming sides.
CAUTION: Make sure the drive shaft
inside the shaft engages with the recess
in the cutting head.
9