To Empty The Grass Catcher; To Get A Good Result; Maintenance; Maintenance Schedule - Husqvarna L 321AH Manual Del Usuario

2. Install the discharge chute.

To empty the grass catcher

CAUTION: Do not drag the bag when you
empty the grass catcher to prevent wear.
1. Lift the grass catcher with the frame handle.
Introduction
WARNING: Before you do maintenance, you
must read and understand the safety
chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.

Maintenance

Do a general inspection
Examine the oil level
Clean the product
1240 - 001 - 08.07.2019
2. Remove grass clippings from the grass catcher from
below the handle.
3. Empty grass clippings from the bag with the frame
handle and the bag handle.

To get a good result

• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
• Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
• Cut in different directions each time to prevent
stripes in the lawn.
Maintenance

Maintenance schedule

The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * refer to instructions in
Safety devices on the product on page 5 .
CAUTION: Make sure that the air filter is up
and not against the ground when you tilt the
product. Risk of engine damage.
Daily Weekly
X
X
X
Monthly
11