Engine Oil; Wheels And Blades - Husqvarna V554 Manual Del Operador

LUBRICATION

Engine oil

NOTE: Change the engine oil when the engine
is warm. Refer to the engine owner's manual
for the correct replacement oil and filter change
recommendations.
WARNING! The engine drain plug is
located close to the muffler. To prevent burns,
the engine should be shut off and allowed to
cool slightly so the engine is still warm but the
surrounding surfaces and oil are not.
1. Park on a level surface. Engage the park
brake.
2. Clean the dirt and debris from the area around
the oil fill cap.
3. Remove the cap/dipstick.
4. Lower or remove the operator cushion to
access the drain hose at the left rear of the
engine.
5. Route the drain hose down through the hole
in the frame.
6. Put an adequately sized container under the
end of the drain hose and remove the oil drain
plug.
7. Let the oil fully drain from the engine.
8. Replace the drain hose plug and tighten
securely.
9. Fill the engine with new oil as recommended
by the engine manufacturer (see the Engine
Manual).
10. Remove the hose from the frame and secure
it into the original position.
11. Check the level with the dipstick.
12. Replace the oil fill cap securely when the oil
level is FULL.
13. Refer to the Service Journal for oil checking
and changing intervals.
28

Wheels and Blades

Use only good quality bearing grease. Grease
from well-known brand names (petrochemical
companies, etc.) usually maintains a good quality.
Front Wheel Mount
Remove dust cap to expose zerk. Lubricate with
a grease gun until the grease is forced out around
the top washer.
Front Wheel Bearings
Lubricate 3-4 strokes with a grease gun on each
set of wheel bearings.
Deck Spindles
1. Lower the cutting deck completely.
2. A grease gun with a rubber hose must be
used to access the center spindle.
3. Lubricate with a grease gun, 2-3 strokes per
spindle.