Midwest Pet Gate 2929SW Manual Del Usuario página 4

If you intend to use the optional drywall anchors, drill
a pilot hole and insert the anchors into the center of
each marked circle. (Refer to illustration a & b for use
with anchors and illustration c for use without drywall
anchors.)
NOTE: The Adhesive Mounting Pads are included only
for positioning the mounting cups and must be used in
conjunction with screws.
Remove the liner from one side of the Adhesive
Mounting Pads, then place and stick a pad inside each
of the four pencil-marked circles. Remove the other liner
from each Mounting Pad and place the Mounting Cups on
each pad. Fasten the Mounting Cups to the wall using
the screws included in the hardware bag.
Installing the Gate in the Opening
4. Begin by positioning the gate level and centered in the
doorway opening. NOTE: It is important to install the gate
with a spacing of no more than 2.5" from the floor, and to
make sure the gap between the side walls and the gate is
no more than 2.5" on each side of the gate.
Pull the 4 Threaded Spindle Bolts out of the ends of the
frame tubes until the Pad touches the wall. **If you are
using the Mounting Cups, the pads should go into the
Mounting Cups that are fastened to your wall.**
5. While holding Pads against the wall, turn the Adjustment
Wheels counter clockwise until the adjustment wheels are
up against the ends of the frame as shown. DO NOT
TIGHTEN. Go to step 6 for final adjustment. HELPFUL
HINT: In might be necessary to hold the Threaded Spindle
Bolt while turning the Adjustment Wheel to ensure the
Threaded Spindle Bolt doesn't turn.
4