Set-Up And Start-Up - Oase Lunaqua Mini LED Instrucciones De Uso

- GB -
− Extension cables and power distributors (e.g. outlet strips) must be suitable for outdoor use.
− Install the transformer at a minimum safety distance of 2 m from the water.
− Ensure that the power connection cable cross section is not smaller than that of the rubber sheath with the
identification H05RN-F. Extension cables must meet DIN VDE 0620.
− Protect the plug connections from moisture.
− Only plug the unit into a correctly fitted socket.
Safe operation
− Never operate the unit if either the electrical cables or the housing are defective!
− Do not carry or pull the unit by its electrical cable.
− Route all cables such that damage is excluded and nobody can trip over them.
− Never open the unit housing or its attendant components, unless this is explicitly required in the operating
instructions.
− Only use original spare parts and accessories for the unit.
− Never carry out technical modifications to the unit.
− Only have repairs carried out by customer service points authorised by OASE.
− Only operate the unit with the supplied transformer.
− Keep the socket and power plug dry.
− The power pack and the plug connectors of the power cables supplied are not water-tight, but only rain and splash-
proof. Do not route or fit in the water.
− Do not look directly into the beam source!

Set-up and start-up

The unit is supplied fully assembled as a complete set containing a power pack and three LED spotlights. When set up
above the water level, maintain a safety distance of at least 50 cm from combustible material. Ensure a safe seating.
Do not cover the unit. Danger of fire!
Position the unit such that it does not present a hazard for anybody. As an option, you can bolt the foot on a firm
ground or a load bearing wall (A1). Adjust the light tilt and arrest this angle with the screw connection (A2).
Connect the plug of the spot light power cable to the transformer socket. Plug the transformer power cable in the mains
socket. Check the spotlight function.
The LED light cannot be dimmed. The brightness of an LED reduces as the operating time increases.
Attention! Sensitive electrical components.
Possible consequence: The unit will be destroyed.
Protective measure: Do not connect the unit to a dimmable power supply.
Attention! The unit becomes very hot during operation.
Possible consequence: Combustible materials in the surrounding area could catch fire.
Protective measure: Do not operate the unit in the vicinity of combustible materials.
Maintenance and cleaning
Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures:
− Prior to reaching into the water, disconnect the power supply to all units used in the water.
− Disconnect the power plug prior to carrying out work on the unit.
Cleaning the unit
If necessary, clean the unit with clear water using a soft brush.
− Ensure that no moisture can enter the unit.
8