4.3.3) Cancellation of the positions or RDC function
To modify the previously memorised positions, they must firstly be cancelled and then the new positions programmed again.
Table "A6"
Cancellation of the intermediate position "I"
Press and hold down button ■ of a previously memorized transmitter until you hear a
1.
beep (after about 5 seconds).
Release and press again button ■ for another 5 seconds until 4 rapid beeps are heard.
2.
Press buttons ▼ and ▲ together until 5 beeps are heard, indicating that the
3.
intermediate position has been cancelled.
Table "A7"
Cancellation of positions "0" and "1"
Press and hold down button ■ of a previously memorized transmitter until you hear a
1.
beep (after about 5 seconds).
Release and press again button ■ for another 5 seconds until 4 rapid beeps are heard.
2.
Press button ▼ until 5 beeps signal that positions "0" and "1" have been cancelled.
3.
WARNING: After positions "0" and "1" have been cancelled the awning will move with hold-to-run and a new position needs to be memo-
rised.
Note: the intermediate positions "I" and the RDC function that are programmed are not cancelled. If you wish to cancel everything (including
the codes of the transmitters), refer to table "A11".
Table "A8"
Cancellation of the torque reduction function (RDC)
Press and hold down button ■ of a previously memorized transmitter until you hear a
1.
beep (after about 5 seconds).
Release and press again button ■ for another 5 seconds until 4 rapid beeps are heard.
2.
Press button ■ until 5 beeps signal that RDC function has been deactivated.
3.
Note: Now the awning will close at full force.
4.3.4) Programming of the "FRT" function
After having programmed positions „0" and „1", position "2" can be programmed that activates the retraction function FRT of the fabric.
Follow the indications in table "A9" to program position "2".
Table "A9"
Programming position "2"
Press and hold down button ■ of a previously memorized transmitter until you hear a
1.
beep (after about 5 seconds).
Press and hold buttons ■ ▼ for another 5 seconds until 2 rapid beeps are heard.
2.
At this point the awning automatically moves to the position of the lower limit switch
(position "1").
Use buttons ▼ and ▲ within 5 seconds to position the awning in the desired
3.
retraction position.
Confirm the position with button ■ of the transmitter within 5 seconds until 3 beeps are
4.
heard. Afterwards the awning will move to the lower programmed limit switch position
(position "1").
Note: if the programming described in point 4 is not confirmed the modifications are aborted and the previous programming is maintained.
If after having programmed this function you wish to eliminate it, the procedure in table A10 must be followed, omitting step 3 which would
modify position "1".
When position "2" is programmed, the electronic control unit automatically calculates the difference between positions "2" and "1", so that
each time a lower command is given, the awning lowers to the greater of the two positions and then retrieves the fabric until arriving to the
lesser of the two positions.
www.stobag.com
Example
5s
5s
Example
5s
5s
GB
Example
5s
5s
Example
5s
5s
37