Mestra R-100140 Manual Del Usuario página 9

8. Timer button
Timer quick set button. Press timer button, LED display shows
by 5 minutes.
Timer decreasing button
9.
Each pressing reduces the timer by 1 minute.
USO DEL APARATO
1
Remove the lid, put the items in the basket. Then put them in the cleaning
tank. Add water or a cleaning solution to a level between min. and max. and
above the area to be cleaned. In order to prevent scratches and friction of
the products, do not pile them up.
If the unit is turne don without water, ultrasonic energy will not be absorbed.
Once over 30 seconds, it may damage the unit or severely reduce the life of
the unit.
2
Connect the power cord (L) and turn the switch on (I). LED display shows
. This is the most commonly used time setting and working state.
If the time needs to be adjusted, press Time button and
can be set between 1 to 30 minutes. Common cleaning time are 5, 10 or 15
minutes.
Prolonged cleaning time may result in:
d. Loosening of the screws if used.
e. Increasing the pre-existing cracks.
f. Peeling of coating which was already separated.
3 Press On/Off button twice to start cleaning.
During cleaning, buzzing sound can be Heard from the cleaning tank,
indicating the cleaning is underway. Closing the lid will reduce the noise.
LED display will count down to show the remaining cleaning time. When it
displays , the cleaning is done. To stop cleaning at any time, press
On/Off button twice.
The unit is designed with overheating protection to avoid damage caused by
extended and continuous operation. When the red light is on, the unit will
not turn on even it is forced to. The unit will idle for about 20 minutes. Then
can be restarted after the green light comes on.
4
When the heater is needed, press Heater button twice,
indicating the heater is turne don.
When water temperature reaches 60 ºC (140 ºF) the heater will turn off
automatically.
To ensure safety, the unit is designed with dual protections. The heater will
be turned off automatically if it has been running for 45 minutes.
To speed up the mixing when solution is used, degas function can be used.
Press time button to set the timer. Press function button,
Press On/Off twice to start degassing. It changes over to normal cleaning
after 90 seconds.
When debris "smoke" is no longer visible, cleaning is done. If additional
cleaning is needed, press time button to reset the timer and repeat the steps
above.
5
When cleaning is completed, turn off the switch, remove the lid and retrieve
the items. Pour water out through the pouring recess. Clean and wipe the
tank dry.
. Each pressing makes it to increase
button. The time
flashes,
illuminates.
9