Emerson ASHLAND CF717BS01 El Manual Del Propietario página 7

3. Installing Hanger Ball/Downrod Assembly
3.6
Reinstall the hanger ball (Figure 6) on the downrod as
follows. Route the 80-inch motor leads through the hanger
ball. Position the pin through the two holes in the downrod
and align the ball so the pin is captured in the groove in
the top of the hanger ball. Pull the hanger ball up tight
against the pin and securely tighten the setscrew in the
hanger ball. A loose setscrew could create fan wobble.
WARNING
!
It is critical that the pin in the hanger ball is properly
installed and the setscrew securely tightened. Failure to
verify that the pin and setscrew are properly installed
could result in the fan falling.
3.7
The fan comes with blue, black and white leads that are
80-inches long. Before installing the fan, measure up
approximately 6 to 9-inches above top of hanger ball/downrod assembly (Figure 7). Cut off excess leads
and strip back insulation 1/2-inch from end of leads.
(For Standard Mounting) (Continued)
PIN
DOWNROD
Figure 6
1/2-INCH
6 TO 9
INCHES
Figure 7
Please contact 1-800-654-3545 for further assistance
7
HANGER BALL
SETSCREW
BLACK WIRE
BLUE WIRE
WHITE WIRE
HANGER BALL
emersonfans.com
ETL Model No.: CF717-1