Outline And Dimensions; Safety Precautions - Daikin FWF02AATNMV1 Manual De Instalación

Indoor Unit: FWF02AAYNMV1 / FWF03AATNMV1 / FWF04AATNMV1
! WARNING
• Installation and maintenance should be performed by
qualified persons who are familiar with local code and
regulation, and experienced with this type of appliance.
• All field wiring must be installed in accordance with the
national wiring regulation.
• Ensure that the rated voltage of the unit corresponds to
that of the name plate before commencing wiring work
according to the wiring diagram.
• The unit must be GROUNDED to prevent possible hazard
due to insulation failure.
• All electrical wiring must not touch the water piping or
any moving parts of the fan motors.
• Confirm that the unit has been switched OFF before
installing or servicing the unit.
• Risk of electric shock, can cause injury or death.
Disconnect all remain electric power supplies before
servicing.
• DO NOT pull out the power cord when the power is ON.
This may cause serious electrical shocks which may result
in the fire hazards.
• Keep the indoor and outdoor units, power cable and
transmission wiring, at least 1m from TVs and radios, to
prevent distorted pictures and static. {Depending on the
type and source of the electrical waves, static may be heard
even when more than 1m away}.

OUTLINE AND DIMENSIONS

570 250
75
98
WATER INLET
WATER OUTLET

SAFETY PRECAUTIONS

364
SEE DETAIL A
DETAIL A
! CAUTION
Please take note of the following important points when
installing.
• Ensure that drainage piping is connected properly.
If the drainage piping is not connected properly, it may
cause water leakage which will dampen the furniture.
• Ensure that the unit's panel is closed after service or
installation.
Unsecured panels will cause the unit to operate noisily.
• Air swing connector and LED wire connector shall be
inside the control box.
• Sharp edges and coil surfaces are potential locations which
may cause injury hazards. Avoid from being in contact
with these places.
• Before turning off the power supply set the remote
controller's ON/OFF switch to the "OFF" position to
prevent the nuisance tripping of the unit. If this is not done,
the unit's fans will start turning automatically when power
resumes, posing a hazard to service personnel or the user.
• Do not operate any heating apparatus too close to the air
conditioner unit. This may cause the plastic panel to melt or
deform as a result of the excessive heat.
• Ensure the color of wires of the outdoor unit and the
terminal markings are same to the indoors respectively.
• IMPORTANT : DO NOT INSTALL OR USE THE AIR
CONDITIONER UNIT IN A LAUNDRY ROOM.
1
640
408
All dimensions are in mm/ (in)