Care And Cleaning - Petsafe Healthy Pet Simply Feed Manual De Funcionamiento

Care and Cleaning

The Healthy Pet Simply Feed
are: stainless steel bowl, bowl holder, hopper lid, hopper and conveyor. The stainless
steel bowl, bowl holder, hopper lid and hopper are dishwasher safe. Only clean the
conveyor by hand-washing using cool or warm soapy water. These washable parts can
be submerged in water. Rinse and let all parts air dry completely before assembling pet
feeder. DO NOT use hot water, submerge the hopper base in water or
clean the conveyor in an automatic dishwasher.
To Clean Pet Feeder:
1. If you have any food in the pet feeder, press UP and ENTER buttons AT SAME
TIME to unlock 5-button Navigation. Next run the "To Prepare Conveyor with
Food" cycle by pressing the ENTER and LEFT buttons AT SAME TIME. This will
dispense any food remaining in the conveyor and hopper into the bowl. Repeat
the "To Prepare Conveyor with Food" until no more food is dispensed or just a few
pieces of food are dispensed from the pet feeder.
2. Set pet feeder to PAUSE FEED MODE. This
keeps the conveyor in sync with the feeding
schedule when reassembled.
3. Remove stainless steel bowl from bowl holder
by first lifting up back of bowl and then front.
4. Remove lid by pulling back finger latch then lifting up using finger grips (see
"Remove From Package" section).
5. Remove hopper by pressing hopper
release button on back of pet feeder
then lift to remove (see "Clean
Removable Parts" section).
6. Remove conveyor by pulling back
red conveyor latch to unlock.
Lift to remove (see "Clean
Removable Parts" section).
7. Remove conveyor crumb catcher by gently pressing in sides and pulling down.
8. Remove bowl
holder by
releasing one
tab on inside of
pet feeder base
using a finger-
nail or screw
driver while
gently pulling
down on same
comes apart for easy cleaning. The washable parts
™
Do NOT immerse control panel in water. Base unit should
NOT be submerged in water at any time, as this may damage
electronic components.
www.petsafe.net 21