REMOVING THE FILTERS (CONTINUED)
The Permanent Washable Mesh Pre-filter is attached
to the inside of the rear grille.
• To remove pre-filter, take the rear grille off and
place it on a flat surface as shown in Fig. 4.
• Gently squeeze the flexible plastic frame of the
mesh pre-filter to release it from the holding tabs.
• To re-insert the mesh pre-filter, line up the notches
on the pre-filter with the plastic holding tabs on the
inside of the rear grille and gently squeeze frame to
secure it under the plastic tabs on both sides.
NOTE: If the odor reducing
pre-filter is used in lieu of the permanent washable mesh pre-filter, it will need to
K
be replaced approximately every 3 months and should be installed in the same location when the washable
mesh pre-filter is removed. It should be tucked under the tabs on the sides of the rear grille to secure it in place.
CLEANING THE IFD
FILTER
®
The ifD
filter should be cleaned approximately every 3 months.
®
Turn the power off and unplug the air purifier.
After removing the ifD
filter from the air purifier,
®
follow the steps below to clean the ifD
filter.
®
• Rinse the filter with clean tap water (Fig. 5)
• If the filter still appears dirty, proceed to "Washing,"
otherwise proceed to "Drying."
Washing:
• Remove the ifD
filter from the unit.
®
• Fill a sink with lukewarm water and add a few drops of mild dish soap.
• Gently swish the filter in the soap solution to clean.
• Soak the filter for 2-3 minutes. Do not leave for an extended period of time.
• Rinse the filter with clean tap water (Fig. 5) and proceed to "Drying".
Drying:
• Shake the filter to remove any excess water.
• Place the filter with the honeycomb side down on a plush towel.
• Note that the filter may still be discolored even after washing.
This is acceptable and will not affect performance.
• Allow the ifD
filter to dry for a few hours or overnight.
®
• When the ifD
filter is completely dry, place back into the air purifier.
®
CAUTION:
• Never place a wet ifD
filter in your air purifier.
®
• The ifD
filter is NOT dishwasher safe. Do not place the ifD
®
other extreme hot water conditions.
• Do not use any solvents, strong cleaning agents or flammable liquids to clean the ifD
6
Fig. 4
Fig. 5
filter in a dishwasher or subject it to
®
filter.
®
MAINTAINING THE WASHABLE MESH PRE-FILTER
The mesh pre-filter helps capture large airborne particles
that enter the rear grille. This pre-filter can be periodically
removed and shaken or vacuumed clean. Alternatively, it
can be rinsed by hand under warm water to clean. (Fig. 6)
Let the pre-filter air dry completely before inserting back
into the grille (Fig. 7). If you need to replace this item,
please call 1-800-477-0457.
OPTIONAL: Changing the Odor Adsorbing Pre-Filter
If you have chosen to use the odor adsorbing
with your air purifier, it will lose its effectiveness for odor adsorption
over time and will need to be replaced.
To purchase additional
pre-filters, see Accessories and
K
Replacement Filters section below.
If using the odo r adsorbing pre-filter, it is recommended that you
store the original washable pre-filter in the event that you decide to
use it in the future.
To insert it into the unit, simply place securely into the rear grille in
lieu of standard pre-filter as shown in Fig. 7.
NOTE: The odor adsorbing pre-filter is not washable.
CLEANING AND STORAGE
We recommend that you clean the air purifier at least once every 3 months and before extended storage.
Use only a dry cloth to wipe the external surfaces of the air purifier. DO NOT USE WATER, WAX POLISH,
OR ANY CHEMICAL SOLUTION.
ACCESSORIES AND REPLACEMENT FILTERS
There is an optional pre-filter that can be purchased and used with this air purifier that will help reduce
common household odors and VOCs. This
K
washable pre-filter that is supplied with the air purifier. The optional
every 3 months for optimum odor and VOC reduction performance.
You may purchase Honeywell replacement Odor & VOC Reducing Pre-filter
purchased your air purifier or they can be ordered directly from www.replacementfilters.com
Odor & VOC Reducing Pre-Filter
: Model HRF-K2 (2 pack)
K
If you have any questions about your ifD
filter or the Washable Mesh Pre-filter (HFD280B-PF),
®
Fig. 6
Mesh
Washable
Pre-filter
Fig. 7
pre-filter that came
K
Pre-filter (HRF-K2) can be used in lieu of the permanent
Pre-filter should be replaced
K
K
at the store where you
Rear Grille
Washable
Mesh Pre-filter
(or Optional
Odor Reducing
Pre-filter)"
K
7