Installation; Horizontal Sliding Window Installation - Kenmore 580.74066 Manual Del Propietário

INSTALLATION HARDWARE INSTALLATION
NO. NAME OF PARTS Q'TY
1 Curtain 1
2 Curtain Frame 1
3 Upper Guide 1
4 Side Guide 2
5 Support Bracket 1
6 Bracket 1
7 Leveling bolt & nut 1
8 Bolt 2
9 Nut 2
10 Washer 2
11 Side Guide seal 1
12 Foam Seal Strip 1
13 Window Track Seal 1
14 L Bracket 1
15 Screw (Type A) 9
16 Screw (Type B) 3
17 Screw (Type C) 8
REQUIRED TOOLS:
• Tight Fitting gloves
• Standard screwdriver
• Phillips screwdriver
• Pliers
• Sharp knife
• 3/8-inch open end wrench or adjustable wrench
• 1/4-inch hex socket and ratcher
• Tape measure
• Electric drill
• 1/4-inch drill bit
Pick a location that will allow the air conditioner to
blow the cold air into the area you want. Windows
used for installation must be strong enough to
support the weight of the air conditioner. Good
installation with special attention to the proper
position of the unit will lessen the chance that
service will be needed.
When cooling more than one room, installation
location is very important. To cool your rooms, cold
air must be blown from the air conditioner in a
straight path.
HORIZONTAL SLIDING
WINDOW INSTALLATION
M Loosely attach the Support Bracket to the
bottom of Bracket using Bolts, Washer, and Nuts.
Attach the Leveling bolt and nut. (Fig. 1)
_b,,11 Bolt
__Bracket
Washer_ __
Nut_ 4
Support Bracket_ veling Bolt & Nut
FIG. 1
_ Remove protective backing from Window Track
Seal and apply seal to window track. (Fig.2)
_-'_ Measure and lightly mark a line 8-1/4 inches
from window jamb. Center the Support Bracket
assembly on the window track and fasten with
Type C screws.(Fig. 2)
WindowJamb
JWin_dow Track
7" Seal
FIG. 2
-6-