Heath Zenith 6106 Manual De Instrucciones página 2

WARNING: Turn power off at the
circuit breaker before wiring.
INSTALLING SENSOR
Typical Installation
1. Remove existing wall switch from junction
box.
2. Connect electrical leads of sensor as shown
in Figure 2. IMPORTANT: Before installing
sensor into junction box, make sure there is no
wire exposed at each connection.
3. Mount sensor into junction box using two large
mounting screws provided.
1
Test
T I M E
Figure 2 - Connecting Electrical Leads of Sensor
BLACK
5
10
15
25
GREEN (Ground)
BLACK
TESTING
1. Remove the decorative cover plate (secured by
two small screws).
2. Pinch control panel cover at the indicated points
as shown in Figure 3. Pull to remove cover.
Decorative
Cover
Plate
Pinch Here
Figure 3 - Removing Control Panel Cover
WHITE
GREEN/BARE (Ground)
BLACK
2
Pinch Here
WHITE
598-1232-01