Replacing The Drive Belt - Dirty Pro Tools A805 Manual De Instrucciones

USER GUIDE
MAINTENANCE

REPLACING THE DRIVE BELT

1. Remove the Screw from the Belt Cover, then remove the Belt cover.
2. Loosen the three Screws to allow the Drive Pulleys to shift enough to place the Drive
Belt around them.
3. Place the Drive Belt around the Drive Pulley, then around the other Drive Pulley.
4. Tighten the three Screws slightly.
5. Adjust the tension of the Drive Belt by placing a screwdriver in the adjusting hole and
pushing up on the screwdriver to apply tension to the Drive Belt.
6. Tighten the three Screws firmly.
7. Grasp the Drive Belt with two fingers on the outside centre and squeeze. There should
be about 7mm give to the Drive Belt for proper tension.
8. Replace the Belt Cover.
Please Note: Too much tension on the Drive Belt can over load the motor and could
cause damage. If the Drive Belt is too loose, it may fail prematurely.
14