Philips SRU6080 Manual Del Usuario página 10

Setup, cont.
Setting and Clearing Timers (TIMER SETUP)
The remote can be programmed with up to 4 Timers (Timer
1, 2, 3 & 4). Each Timer can be assigned up to 4 keys (4 if
Macros enabled, 2 if Macros disabled) to activate at the set
time. The first key must always be a Mode key.
Subsequent keys cannot include Up, Down, Left, Right,
OK, Exit, Macro, Setup or any Mode key. Timers can only
activate within the following 24-hour period. Timers are
automatically cleared after activation. The "Timer Bell"
symbol is displayed when any Timer is set.
To set a Timer (Note, the Timer must be cleared first if it was
previously set – see To Clear a Timer below)
1. Press and hold the SETUP button until CODE SETUP is
displayed (takes about 3 seconds), then release the SETUP
button.
2. Press the down navigation button until TIMER SETUP is
displayed.
3. Press and release OK. TV SLEEP SETUP is displayed.
4. Press the down navigation button until TIMER X SETUP
is displayed (where "X" is 1, 2, 3 or 4). Press and release
OK.
5. TIMER X SET is displayed. Press and release OK.
6. TIMER X TIME?" is displayed with the "hours" flashing.
Use the Up/Down buttons to set the hours then press
and release OK.
7. The "minutes" will be flashing. Use the Up/Down buttons
to set the minutes then press and release OK.
8. TIMER X MODE? is displayed. Press and release the
desired Mode key (TV, VCR, DVD, etc.).
9. TIMER X Key1? is displayed. Press and release the first
key required. If only one key is required, press and release
OK at this point – go to Step 12 below. If Macros are
disabled, go to Step "l" below.
10. "Timer X Key2? is displayed. Press and release the second
key required. If only two keys are required, press and
release OK at this point – go to Step 12 below.
11. TIMER X Key3? is displayed. Press and release the third
key required.
12. SUCCESS is displayed and the remote remain in Setup
Mode, returning to the CODE SETUP screen. Press QUIT
then OK to exit Setup Mode.
18
Setup, cont.
To clear a Timer ("Timer Bell" in normal display)
1. Press and hold the SETUP button until CODE SETUP is
displayed (takes about 3 seconds), then release the SETUP
button.
2. Press the down navigation button until TIMER SETUP is
displayed.
3. Press and release OK. TV SLEEP SETUP is displayed.
4. Press the down navigation button until the desired TIMER
X SETUP is displayed (where "X" is 1, 2, 3 or 4) screen.
Press and release OK.
5. TIMER X CLEAR is displayed. Press and release OK.
6. CONFIRM CLEAR is displayed. Press and release OK.
7. SUCCESS is displayed and the remote remains in Setup
Mode, returning to the CODE SETUP screen. Press QUIT
then OK to exit Setup Mode.
19