Petsafe 100 Serie Guia De Inicio Rapido página 6

10. Set the exterior frame on top of the remaining adaptor plate and attach
using the two (2) 16mm ( ₅ ⁄₈") flat head screws (included).
11. From the exterior of the home, place the exterior frame with installation
adaptor attached onto the tunnel of the interior frame and mark the four (4)
screw holes on the installation adaptor plate. Remove the exterior frame.
12. Using the proper hardware for your wall construction (not included), drill
the appropriate size holes for your hardware, and attach the exterior
frame assembly to the wall.
13. Insert the 8 blanking plugs into the exterior and interior installation
adaptor plates and 2 blanking plugs into the exterior frame.
14. Remove the batteries from the cat flap and wait for 30 seconds. Re-install
the batteries and battery cover. The cat flap is ready to use.
Installation – Single-Glazed Glass
The PetSafe Microchip Cat Flap is designed for installation into single-glazed
®
glass and requires a circular hole with a diameter of 215 mm (8 ₇ ⁄₁₆"). Your
glazier will need to cut a circular hole of diameter 215 mm (8 ₇ ⁄₁₆") as per the
cutting template. Once a glazier has cut the hole in your glass door or window
please follow the instructions below for installation.
1. From the interior of the home, insert the cat flap interior frame into the opening.
2. From the exterior of the home, place the exterior frame onto the tunnel of the
interior frame.
3. Make sure to center the cat flap in the hole. Three (3) different lengths
of screws have been provided with this cat flap. Select the appropriate
length. Using a manual screw driver, screw the exterior frame to the
interior frame.
4. Insert the two blanking plugs over the screws on the exterior frame.
5. Remove the batteries from the cat flap and wait for 30 seconds. Re-install
the batteries and battery cover. The cat flap is ready to use.
Working with glass is a skilled job and should be carried
out by a professional glazier. It is not possible to cut holes in toughened glass or
double glazed units except at the time of manufacture. Please consult a glazier.
6
Installation – Double-Glazed Glass
The PetSafe ® Microchip Cat Flap is designed for installation into double
glazed glass and requires a circular hole with a diameter of 260 mm (10 ¼")
and an Installation Adaptor (sold separately.) If possible, have your glazier
use non-metal materials when sealing the glass to prevent the cat flap's read
range from being reduced. Once your glazier has installed the new glass
panel with a 260 mm hole, please follow the instructions below for installation.
1. Slide one installation adaptor plate over the tunnel on the interior frame of
the cat flap.
2. From the interior of the home, insert the cat flap interior frame with
installation adaptor into the opening.
3. From the exterior of the home, place the remaining installation adaptor
plate onto the tunnel of the interior frame followed by the exterior frame of
the cat flap.
4. Make sure to center the installation adaptor in the hole. Three (3) different
lengths of screws have been provided with this cat flap. Select the
appropriate length. Using a manual screw driver, screw the exterior frame
to the interior frame.
5. Insert the eight (8) blanking plugs into the exterior and interior installation
plates and two (2) into the exterior frame.
6. Remove the batteries from the cat flap and wait for 30 seconds. Re-install
the batteries and battery cover. The cat flap is ready to use.
out by a professional glazier. It is not possible to cut holes in toughened glass or
double glazed units except at the time of manufacture. Please consult a glazier.
petsafe.com
Working with glass is a skilled job and should be carried