Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Fasten torque not reach setting
#1 release trigger
#2 over 5 seconds
#3 over 10 seconds
Push lever to reverse position
Hydraulic Oil Changing Alert
Setting Torque Reached and
Motor Shut-off Right Away
Connect to iPad
To push the switch lever to the right side on the bottom of the foot as the following
picture:
Note: Refer to the iPAD App setting manual for iPAD operation settings.
Connect to I/O Receiver
To push the switch lever to the left side on the bottom of the foot as the following
picture:
1English1
#1 RED Bright & Buzzer
Alarm Alternatively
#2 RED Blinking
#3 RED Bright & Buzzer
Alarm Alternatively
RED & Green Blinking
Simultaneously
Green Blinking for 3 Sec
(If no use lasting 3 min, alert
signal will blink again once
pressing the trigger.)
Green Bright
Buzzer Alarm
English
-14
Abnormal Shutoff
Release Trigger, then Re-
tightening
Push lever to forward position,
blinking stop
Contact Service Centre to
Replace Oil
Normal Shutoff
Tabla de contenido
