VWR 444-7084 Manual De Instrucciones página 12

A
CCESSORIES
TEST TUBE RACKS
- Requires Platform accessory.
D
ESCRIPTION
10 to 13mm Test Tube Rack
14 to 16mm Test Tube Rack
18 to 20mm Test Tube Rack
22 to 25mm Test Tube Rack
15mL Centrifuge Tube Rack
50mL Centrifuge Tube Rack
1.5 to 2mL Micro-Tube Rack
Installation of Test Tube Racks:
1. Unit should be in standby mode.
2. Remove non-skid rubber mat. Slide Platform over-top included tray.
3. Using the hardware provided, attach brackets to the Platform. Position
brackets as shown. The proper spacing between the brackets is 19.7cm.
4. Align the test tube rack side-to-side with the brackets on the Platform.
5. Press the test tube rack in place, you will hear the test tube rack clip into
position. No mounting screws are required.
11
T P
UBE LATFORM
C C C . N
APACITY APACITY AT
63 2 444-0278
48 2 444-0279
35 2 444-0280
24 2 444-0281
42 2 444-0283
12 2 444-0284
70 2 444-0276
FLASK CLAMPS
- Requires Platform accessory.
. D
O ESCRIPTION
10mL Erlenmeyer Flask Clamp
25mL Erlenmeyer Flask Clamp
50mL Erlenmeyer Flask Clamp
125mL Erlenmeyer Flask Clamp
250mL Erlenmeyer Flask Clamp
500mL Erlenmeyer Flask Clamp
1L Erlenmeyer Flask Clamp
500mL Media Bottle Clamp
1L Media Bottle Clamp
Installation of Flask Clamps:
1. Unit should be in standby mode.
2. Remove non-skid rubber mat. Slide Platform over-top included tray.
3. Line up the hole(s) in the flask clamp to the hole(s) in the Platform.
Using the screw(s) provided, hand tighten into place using a flathead
screwdriver. DO NOT over tighten.
4. Insert flask/media bottle into clamp and wrap the spring around the neck
of the clamp to hold secure.
P
LATFORM
M C C
ATERIAL APACITY AT
stainless steel 60 444-7040
stainless steel 30 444-7041
stainless steel 24 444-7042
stainless steel 12 444-7043
stainless steel 8 444-7044
stainless steel 6 444-7045
stainless steel 4 444-7030
stainless steel 6 444-7035
stainless steel 4 444-7036
. N .
O