Tabla de contenido
Idiomas disponibles
Idiomas disponibles
The Comfort Glow portable comfort furnace is not intended to replace your central heating system nor is it
intended to be a sole heating source. Your comfort furnace is intended as a supplemental zone heating source.
The goal of this heater is to reduce the total home heating costs by allowing you to turn back the central heat
system and provide supplemental heat to the rooms being occupied.
The Comfort glow portable comfort furnace is not an instant room heater. It may take 24-36 hours for your heater
to reach maximum efficiency. The portable comfort furnace will warm all the elements in the area being heated
(furniture, floors, walls etc.) This will take some time based on the size of the area, insulation ambient
temperature and many other factors but once these elements are heated they will help to maintain a steadier
room temperature and less on/off cycling of your central heat. You will notice that the furnace does not rely on
high speed flow of air. This sensitive flow is by design. The purpose of the built in circulator is to move a large
volume of air without creating hot/cold spots in the area being heated, and thereby promoting a more consistent
room temperature.
Please follow these suggestions:
1)
Close doors to areas you do not wish to heat.
2)
Locate a three prong outlet along an interior wall if possible. Position the heater so that the warm air can blow
unobstructed across the room towards the exterior walls.
3)
Check your windows and doors for the infiltration of cold air and insulate as needed to avoid heat loss. Rapid
heat loss will minimize the effectiveness of your Infrared heater as it would any conventional type heater.
4)
Keep the area around the heater free of obstructions to insure maximum airflow. Keep electrical cords,
drapery, furniture, and other combustibles 3 feet (0.9 M) away from the front of the heater and away from the
sides.
5)
Avoid locating your heater in high traffic areas or in direct sunlight.
6)
Avoid locating your heater near your central heating thermostat.
WARNING:
It is normal for the power cord to feel warm to touch; however, a loose fit between the outlet and the
plug may cause overheating of the plug. If this occurs, try inserting the plug into a different outlet. Contact a qualified
electrician to inspect the original outlet for damage.
Tip-Over Safety Feature
This heater is equipped with a tip-over safety feature. Once the heater is tipped over, an internal switch will
automatically shut the heater off. Once the heater is restored an upright position, the heater will reset. To continue
operation, turn on the heater using the supplied remote control or the control panel on the heater.
Overheat Safety Feature
This heater is equipped with a overheat safety feature. When the heater's internal components reach a
certain temperature that could cause overheating or possible fire, the heater will automatically shut off
WARNING! Do not use this product if any part has been under water
WHAT TO EXPECT FROM YOUR COMFORT FURNACE
SAFETY FEATURES
~ 4 ~
.
Tabla de contenido
