Complete The Installation - THE BOLD LOOK OF KOHLER K-9025 Guia De Instalacion

Water-Resistant
Wall Material
Shim
Stud Wall
Flange
Finished Floor
Front Section Of Wall

7. Complete the Installation

Cover the framing and walls with water-resistant wall material.
Install the water-resistant wall material to the framing with the paperbound edge a minimum of
5/8" (1.6 cm) above the receptor deck.
For drop-in installations: Install desired trim to conceal the receptor edge.
NOTE: To ensure proper fit of the shower door, install 1/2" (1.3 cm) to 1-1/4" (3.2 cm) thick wall material
(as measured from the 2x4 stud framing).
Tape and mud the wall material.
Install the finished wall. Seal the joints between the receptor flange and the finished wall with
silicone sealant. RTV (Room Temperature Vulcanizing) sealant is recommended.
Seal around the valving and outlets with silicone sealant or plumbers putty.
Install the faucet and drain trim according to the manufacturer's instructions.
If used, install the grab bars or towel bars to the backing in the stud wall (previously installed).
Follow the manufacturer's installation instructions.
If used, install the shower door according to the manufacturer's instructions.
Install the finished floor. Apply silicone sealant along the front edge of the receptor where it meets
the floor.
8. Clean-Up
CAUTION: Risk of product damage. Do not allow cleaners containing petroleum distillates to remain
in contact with module surfaces for any length of time.
CAUTION: Risk of product damage. Do not use abrasive cleaners.
When cleaning up after installation, use warm water and an approved liquid cleanser to clean the
surface.
Stubborn stains, paint or tar can be removed with turpentine or paint thinner.
Plaster can be removed by scraping with a wood edge. Do not use metal scrapers, wire brushes, or
other metal tools. Use warm water and an approved liquid cleanser to provide mild abrasive action
to remove residual plaster.
1009404-2-D
Drop-in Installation
Finished
Wall
Apply
silicone
sealant
here.
5/8"
(1.6 cm)
Water-Resistant
Wall Material
Apply
silicone
Shim
sealant
here.
Stud Wall
Flange
Sub-Floor
Front Section Of Wall
8
Alcove Installation
Finished
Wall
5/8"
(1.6 cm)
Kohler Co.