Nice smu Instrucciones Y Advertencias Para El Usuario página 4

Table "E" TOTAL deletion of the receiver's memory
This function allows you to delete al the codes entered in the receiver's memory.
1. Press the "Clear" key
2. "P P r r E E S S " will appear on the display. Press the "Clear" key once again to confirm the deletion.
3. During the deletion stage, numbers will scroll by on screen indicating the position reached
by the deletion operation.
4. If the deletion operation has been successfully completed, "E E n n d d " will appear on the display.
Table "F" Copying a receiver's memory (duplicate)
This function allows you to copy the contents of a receiver's memory onto other receivers of the same family.
This function features 2 distinct stages:
Stage1: the receiver's memory is copied onto the SMU's internal memory.
Stage2: the contents of the SMU's memory are copied onto the receiver's memory.
Note: These two stages can be executed at different times since the contents of the SMU's internal memory will remain intact until Stage 1 is exe-
cuted once again. If you wish to copy the contents of a receiver's memory onto other receivers, just execute stage 2 as many times as needed.
Warning: Stage 2 of "Write" deletes any other codes previously entered in the receiver's memory.
Stage1
1. Press the "Read" key
2. "P P r r E E S S " will appear on the display. Press the "Read" key once again to confirm.
3. During this stage, numbers will scroll by on screen indicating the position reached by the
memory reading operation.
4. If the copy operation has been successfully completed, "E E n n d d " will appear on the display.
5. Wait for the SMU to switch off automatically, then remove the receiver
Stage2
6. Connect the radio receiver and press the "Power" key
7. Press the "Write" key
8. "P P r r E E S S " will appear on the display. Press the "Write" key once again to confirm.
9. During this stage, numbers will scroll by on screen indicating the position reached by the
memory writing operation.
10. If the copy operation has been successfully completed, "E E n n d d " will appear on the display.
Table "G" List of display symbols
Symbol Description
The number displayed indicates the memory position where the code is being added, erased or searched for.
0 0 1 1 2 2 3 3
SMU waiting for radio reception.
. . ] ]
] ]
Indicates that the receiver's memory is full, therefore no additional transmitters can be entered.
F F U U L L L L
Indicates that the device is waiting for the key to be pressed again to confirm the function.
P P r r E E S S
Indicates that the transmitter you wish to enter is already stored in the receiver's memory.
A A L L - - P P
Indicates that the transmitter you are searching for is not stored in the memory.
n n o o - - P P
Indicates that a position has been deleted from the memory.
d d E E L L
Indicates the condition of the battery (Bat1= Battery totally exhausted, Bat9= Battery fully charged).
B B a a t t . . . .
Indicates that the battery does not allow any operations to be performed.
b b A A t t t t
Firmware version.
F F ... ...
Indicates that an error has occurred; consult table "H" to solve the problem.
E E r r r r . . . .
4
Example
Clear
P P r r E E S S
Clear
E E n n d d
Example
Read
P P r r E E S S
Read
E E n n d d
Example
Power
White
P P r r E E S S
White
E E n n d d