Controller Installation - Akron 8600 Serie Instrucciones De Instalación

Accionador eléctrico
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

Sector Gear
INLET
INLET
F .
Replace the cover on the actuator and attach with the four round head screws A .
G . Go to Section V .
IV. ELECTRICALLY ACTUATED VALVE INSTALLATION
A . Install the electrically actuated valve into the apparatus piping . To facilitate the installation, the valve adapters may be removed
from the valve body, mounted on the piping and the valve body re-bolted onto the adapterflanges . The actuator may be
positioned on the top, bottom or side of piping . If necessary, the actuator mayalso be rotated on the valve to any of the four
positions shown on the following page .
NOTE: The notch on the top of the trunnion must always be in line with the waterway with the sector gear
positioned as shown .
The valve must not be installed more than 20 feet from master controller. See controller installation instructions.
Do not splice wiring harness or connect through slip (collector) rings on aerials. Auxiliary controller must be used
for this application.
V.

CONTROLLER INSTALLATION

See instructions packaged with controller system .
All positions shown with the ball open
OUTLET
POSITION A
OUTLET
POSITION C
INLET
INLET
3
OUTLET
POSITION B
OUTLET
POSITION D
Tabla de contenido
loading

Este manual también es adecuado para:

86208625

Tabla de contenido