Error Code - Sievert DW 3000 Instrucciones De Uso

Safety Instructions
DW 2000
Maintenance, Service and Repairs
Before any work on the unit: Remove the tool from the power source - Check the power
cord and plug for any visible damage. - For secure and proper operation, keep the unit and
the ventilation slots clean at all time. - Use only original Sievert accessories. If the tool does
not work after following the trouble shooting guide then unit should be taken to an author-
ized Sievert Dealer.
Disposal
Do not dispose this power tool into household waste!
According to European Directive 2012/19/EU (WEEE), power tools that are no longer suit-
able for use must be sent for recovery in an environment-friendly manner in according to
national law.
Trouble shooting
First action in case of error message.
Unplug the tool and wait until the display turns off. Reconnect the tool and test it again.
If the error code persists or the error occurs again during operation see the
troubleshooting list below.

Error Code

CE Declaration of conformity
Sievert AB, P.O. Box 1366, 171 26 Solna - Sweden, manufacturer of this product, declares it complies with the requirements of the
following European Directives:
Directives:
Harmonized Standards LVD:
Harmonized Standards EMC
Harmonized Standards RoHS:
Stockholm, July 2015
Katrin Lambing
Quality Manager Sievert
Cause
Defective heating element
Defective fan
Unit overheated
Low incoming voltage under
90 V ( 160 V : 230 V version)
High incoming voltage
over 130 V ( 250 V : 230 V
version)
Temperature sensor failure
LVD 2006/95/EC
EMC 2004/108/EC
MD 2006/42/EC
RoHS 2011/65/EU
IEC/EN 60335-2-
45:2003+A1:2008 used in conjunction with
IEC/EN 60335-1:2011+A11:2014
EN 55014-1: 2006 + A1: 2009 + A2: 2011
EN 55014-2: 1997 + A1: 2001 + A2: 2008
EN 61000-3-2: 2014
EN 61000-3-3: 2013
EN 50581:2012
Correction
Change heating element, see page 6
Contact Sievert Dealer
Turn off the tool for 3 min and clean air intake
Check power supply, push minus button in
AC.on mode to see incoming voltage
Check power supply, push minus button in
AC.on mode to see incoming voltage
Contact Sievert Dealer
Mathias Karlsson
R&D Department Sievert
GB
8