Midwest Solutions SL54DD Manual Del Usuario página 3

5. Position the top Panel (D) over the
upright side Panels with the hooks
facing downward. Connect the hooks of
the top Panel to the top horizontal wires
of the two upright side Panels. the middle
"l" wire on the top Panel should tuck
inside the side Panel on each side.
6. Position and hang the Front Door Panel
(E). this will go on the open end of the
pet home that has the pan stop attached.
Hang the Door Panel using the two
hangers attached to the top Horizontal
wire. the panel will swing down naturally
into position. the door should be
positioned so that the slide-bolt latches
are on the right side, enabling the door to
open outward from right-to-left.
Finish the panel assembly by lifting the
middle of the top Panel while pushing
inward on the middle of the Door Panel to
hook the top Panel's bent tab around the
top horizontal wire of the Door Panel.
INSERTING THE CORNER RODS
IN THE FRONT
7. Next, you will take two of the Corner rods
(G) and insert them downward through the
various intersecting loops of the two front
corners.
your solutions crate uses an over/under
configuration to increase stability and
security of the crate. Use the guide at the
right, which shows how each panel's loops
should be placed before inserting the rod
on each side. this configuration should be
the same on both sides of the Door Panel.
Door Panel loop only
side Panel loop only
side Panel over
Door Panel Under
Door Panel over
side Panel Under
side Panel loop only
side Panel over
Door Panel Under
3