Fill with water 2" (5.1 cm)
above the highest jet.
Turn the large jet
trim ring clockwise
to decrease the
flow.
Operating Your Whirlpool
NOTE: The jet nozzles can be adjusted for flow. Turn the jet trim rings clockwise to reduce the flow or
counterclockwise to increase the flow.
Position all jet nozzles so they face down toward the basin.
Turn the jet trim rings fully counterclockwise.
Close the drain, then fill the whirlpool to a level at least 2" (5.1 cm) above the top of the highest jet.
Use your hand to test the water temperature for comfort and safety, then carefully enter the bath
basin.
Press the air actuator to turn on the whirlpool.
Adjust the jets for optimum air/water mixture.
Position the jet nozzles to direct the water flow as desired to maximize your hydro-massage
experience.
Press the air actuator a second time to turn off the whirlpool.
Carefully exit the bath, and open the drain to empty the whirlpool.
NOTE: If the whirlpool does not function properly, please refer to the "Troubleshooting" section.
Care and Cleaning
Cleaning Your Vikrell Whirlpool
For best results, keep the following in mind when caring for your STERLING product:
Always test your cleaning solution on an inconspicuous area before applying to the entire surface.
Wipe surfaces clean and rinse completely with water immediately after applying cleaner. Rinse and
dry overspray that lands on nearby surfaces.
Do not allow cleaners to sit or soak.
Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring
pad to clean surfaces.
For detailed cleaning information and products to consider, visit www.sterlingplumbing.com/support.html.
To order Care & Cleaning information, call 1-800-456-4537.
Flushing Your Whirlpool System
Flush your whirlpool system twice a month or more, depending upon usage.
1016905-5-K
Position the jet nozzles
to direct the water flow
as desired.
Turn the large jet trim
ring counterclockwise
to increase the flow.
Press the air actuator to turn
the whirlpool on or off.
4
Sterling